Husqvarna VIKING 1
50 FANCY TRIM FOOT 412823845 1 2 3 4 5 6 7 Not fo
r EMERALD™ 122, 118 and 116 machines, EDEN ROSE™ 250M, TRIBUTE™ 140M. 8 Decorate your project with glittery sequins by using the Fancy Trim Foot. This foot will easily guide the sequins through a groove at the front of the foot, while your sewing machine stitches your fancy trim in place invisible. Only circle round sequins can be used. 1. Thread with invisible thread on top and regular sewing thread in the bobbin. Snap on the Fancy Trim Foot and select a Hand Look Appliqué Stitch. Adjust the stitch length to 4.5 and the width according to the width of your sequins. Make sure to use Tear-Away stabilizer underneath your fabric. 2. Slide the sequins into the groove at the front of the presser foot. Make sure you have pulled a piece of the sequin trim under the foot and through to the back of the foot before you start to sew. Snap on the foot. 3. Start sewing on a scrap of your fabric, since different fabrics behave in different ways. Sew slowly to prevent sewing through the sequins. CHENILLE STITCHING FOOT 412975245 1 2 3 4 5 6 7 * 8 Makes it easy to embellish beautiful chenille effects. For beginners as well as for experienced quilters and sewers. 1. Thread with sewing thread on top and in the bobbin. 2. Use a minimum of three layers of chenille strips, 5/8" wide (16 mm), for a beautiful effect. Place the strips into the presser foot. (You can also use narrower strips like ⅜" wide (10 mm). 3. Snap on the Chenille Stitching Foot. 4. Place the fabric that will be embellished under the presser foot and the strips. 5. Select a straight stitch, a zigzag stitch or a three step zigzag stitch. Select short stitch length and a narrow stitch width, 1.5 – 2. 6. Sew with a slow speed. The Chenille Stitching Foot will guide the strips onto the fabric where you want to have the chenille effect. For extra stability use Tear-Away Stabilizer underneath. 7. Add strips in rows if desired to complete your project. 8. Machine wash project on cold cycle, dry warm. Alternative method: Spray with water, rub with stiff brush to fray strips, then dry with hair dryer. Pre-cut Chenille Bias Tape in various colors is available at your local dealer. * Cannot be used with automatic needle threader DECORATIVE/CRAFTING SEWING