SERGER/OVERLOCK BEADING FOOT 620086696 coverlock™
hobbylock™ The Beading Foot smoothly guides beads and pearls through a channel on the foot for easy application on garments or crafts. 1. Set the overlock machine for the desired stitch. 2. Pull the bead string through the channel on the underside of the foot. 3. Snap the Beading Foot onto the machine. 4. Turn the handwheel to sew the first two stitches to keep the beads in place. 5. Sew pearls onto the edge of fabric, cutting just a little bit of fabric as you sew. Or sew along the fold without cutting. 4.0 and 3.0 2.5 Note: The needle should penetrate about 5/8” (1.5mm) from the fabric edge. DECORATIVE BEADING FOOT This foot is used for sewing on beads, spangles, etc. Preparing the machine • Needle: • Stitch type: • Stitch length: 620117196 hobbylock™ Left or right (left is preferable.) Three-thread overlock or wrapped edge overlock 3-5mm • Differential feed lever: Normal position • Upper knife: 2.0 Working or non-working position Sewing 1. Select sewing method (A) or (B), then determine needle position and sew 2 or 3 stitches. 2. Turn hand wheel with hand until needle point is level with fabric surface on its upward stroke. Then insert the end of string of beads into guide on presser foot. 3. Sew 2 - 3 stitches by turning hand wheel with hand. 4. Press beards lightly with left finger while sewing. 5. Sew the last few stitches by turning hand wheel with hand to avoid beads interfering with needle and loopers. 93