Pfaff 1
SERGER/OVERLOCK LACE FOOT This foot is used for s
ewing lace or borders together or onto the workpiece. Preparing the machine • Needle: • Stitch type: • Stitch length: 620117296 hobbylock™ 2.0 Right needle Three-thread overlock or three—thread standard rolled hem 1.5 - 3 mm • Differential feed lever: Normal position • Upper knife: Working or non-working position Sewing 1. Place the fabric under guide finger (A) and lace on top of guide finger (A). 2. If necessary, loosen screw (C) and slide guide plate (B) to the left or right to adjust stitch width. 3. Tighten screw (C). 4. Guide lace along guide plate (B) and sew. Note: If there is no necessity to cut the fabric edge, place both fabric and lace on top of guide finger (A) . Be sure to disengage the upper knife. DECORATIVE TAPING FOOT 620117696 coverlock™ hobbylock™ The Taping Foot is used to apply seam tapes to seams to prevent stretching. It is especially good for stabilizing shoulder seams. With this foot you can reinforce and construct seams in one step. 1. Set the overlock machine for the 4-thread overlock. 2. Place the seam tape in the guides on the foot. 3. Adjust the screw to fit the width of the tape. 4. Snap the taping foot onto the machine. 5. Sew the seam. 4.0 and 3.0 2.5 Note: Works best with ¼” (8mm) seam tape. 93