PFAFF® Accessory Catalog 2021 - English 1
QUILTING POWERQUILTER FEET NEW! RULER FOOT The ru
ler foot has higher sides to give increased stability when using rulers and the cutout in the side of the foot gives better visibility. TO ATTACH THE RULER FOOT 1. If another presser foot is on the mount, use the 2.5mm hex wrench to loosen the mounting screw far enough that you can slide the foot off of the mount. 2. Slide the Ruler Foot onto the mount. The opening on the side of the foot lines up with the mount’s screw hole. Push the Ruler Foot up as far as it will go. 821257096 powerquiler™ 1600, 1650 3. Ensure the foot is centered over the hole in the needle plate and that the needle is c centered in the foot. Then fully tighten the screw with the 2.5mm hex wrench. ACCESSORIES NEW! ECHO FEET SET The Echo Feet Set contains 3 acrylic presser feet with 3/8“, 1/2“ and 3/4“ widths from the needle to the edge of the foot. These perfect for echo quilting round motifs or when using rulers. TO ATTACH ONE OF THE ECHO FEET 1. If another presser foot is on the mount, use the 2.5mm hex wrench to loosen the mounting screw far enough that you can slide the foot off of the mount. 821258096 powerquiler™ 2. Slide the desired Echo Foot onto the mount. The opening on the side of the foot lines up with the mount’s screw hole. Push the Echo Foot up as far as it will go. 1600, 1650 3. Ensure the foot is centered over the hole in the needle plate and that the needle is centered in the foot. Then fully tighten the screw with the 2.5mm hex wrench. NEW! SQUARE FEET SET The Square Feet Set contains 2 acrylic presser feet with 1/4“ and 1/2“ seam allowances. These feet are designed to help create straight seams when piecing on the quilt frame. TO ATTACH THE SQUARE FOOT 1. If another presser foot is on the mount, use the 2.5mm hex wrench to loosen the mounting screw far enough that you can slide the foot off of the mount. 821256096 powerquiler™ 2. Slide the chosen foot onto the mount. The opening on the side of the foot lines up with the mount’s screw hole. Push the Square Foot up as far as it will go. 1600, 1650 3. Ensure the foot is centered over the hole in the needle plate and that the needle is c centered in the foot. Then fully tighten the screw with the 2.5mm hex wrench. 59