HUSQVARNA® VIKING® Accessory Catalog 2022 1
120 2. CORDED TUCKS Achieve a trapunto effect whe
n a coverstitch is sewn over a cord in the guide. 1. Set the machine for coverstitch, wide. Note: Although the machine recommends needles C and E, you will use needles D and E for this technique instead. 2. Snap on the Piping foot and attach the cording guide as illustrated (illustration 2). 3. Insert the cord into the round hole of the cording guide and position it in the groove on the bottom of the Piping foot. 4. Lay the fabric right side up on top of the cord. Slide it under the foot until it is underneath the needles (illustration 3). 3. 5. Lower the needles into the fabric. Lower the presser foot and start to sew at a medium speed. (Hold the cord behind the foot as you begin to sew.) DECORATIVE TRIM 4. Use decorative thread and ribbons to create special effects and unique trims. 1. Set the machine for 3-thread ornamental flatlock stitch, wide with decorative thread in the loopers. 2. Snap on the standard presser foot and attach the cording guide as illustrated (illustration 4). 3. Insert a ribbon ¼” (6mm) wide right side down into the rectangular opening in the guide. 4. Place the ribbon under the presser foot to the right side of the needle, leaving a 2” (5cm) tail behind the foot. 5. The needle should go down into the machine just beyond, not into, the edge of the ribbon (Illustration 5). 5. 6. Sew over the ribbon to make a decorative trim. Tip: Make your decorated ribbon long enough to cut it in three pieces, then braid (Illustration 6). 6. OVERLOCK SEWING AND COVERSTITCH