Singer Guide ENG 1
DECORATIVE & CRAFTING SEWING BEADING FOOT #250041
296 M/C Code: CD Use the Beading Foot to easily sew beads, cords, yarns, sequins or other trims into place. The deep groove on the underside of the foot will allow piping or beads to be easily stitched into place. 1. Snap the Beading Foot onto the machine. 2. Thread the top of the machine with clear monofilament thread and regular sewing thread in the bobbin. 3. Select zigzag stitch. 4. Position the beads or other trim into the groove of the foot. This will guide the trim as it is stitched. 5. Place fabric under the Beading Foot. Trims may be stitched on the edge or anywhere on the fabric. 6. Adjust zigzag width to accommodate the width of the trim. Turn the handwheel to permit the needle to go left and right to test that the needle will clear the trim and not break. 7. Sew slowly. EDGE JOINING FOOT #250040896 M/C Code: CD The Edge Joining Foot is used to sew two pieces of fabric, lace or trim together side by side. It can also be used for stitching in the ditch, edge stitching, and Hong Kong finishes. The vertical guide in the center of the foot assures that your stitching stays perfectly straight. 1. Snap the Edge Joining Foot onto the machine. 2. Position fabrics or trims against each side of the center guide. 3. Select zigzag, feather, multi-stretch zigzag or other desired stitch. 4. Adjust stitch width to catch fabrics on both sides of the center guide on the Edge Joining Foot. 5. Stitch while keeping the fabrics or trims aligned against the center guide. Note: It is easier to use lace or trims with a flat header. 20